Everyday Use with the Yale EN Fire Safe

Installing/changing the batteries

Turn the outer ring of the lock housing to the left approximately 20°, pull it away from the base. Snap a 9v alkaline battery onto the battery clip and push it back into place. Place the outer ring back into place and turn it clockwise. Make sure to change the Entry Code and Master code.

The Safe is delivered with an activated Master Code (pre-set factory code 1-2-3-4-5-6). For security reasons you should change the Master Code immediately after putting the Safe into operation. The Yale EN Fire Safe Mastercode cannot be changed after initial set up.

A secondary User Code can be added to the Yale EN Fire Safe. This code is in addition to the Master Code and can be changed if needed.

The Safe is delivered with an activated Master Code (pre-set factory code 1-2-3-4-5-6). For security reasons you should change the Master Code immediately after putting the Safe into operation.

To change the Master Code:

Always change the code when the Safe door is open and check several times before closing the door.

1. Enter 0-0-0-0-0-0 (1 beep)
2. Enter existing code (pre-set factory code 1-2-3-4-5-6) 1 Beep
3. Enter new 6-digit code (1 beep)
4. Repeat the new 6-digit code (2 beeps)

Please note: A long beep means the code has not been accepted, try again.

Important:

• Make sure to remember the code or keep in a secure place. 
• The Yale EN Fire Safe Mastercode cannot be changed after initial set up.
• The Safe cannot be opened if the code is forgotten.

A secondary User Code can be added to the Yale EN Fire Safe. This code is in addition to the Master Code and can be changed if needed.

To add a User Code to the Yale EN Fire Safe:

1. Enter the master code and hold down the last digit (2 beeps)
   Please note: Three beeps means the code has not been accepted, try again.
2. Press key '1' (1 Beep)
3. Enter new 6-digit code (1 beep)
4. Repeat the new 6-digit code (1 beep)

Please note: A long beep means the code has not been accepted, try again.

To delete the User Code from the Yale EN Fire Safe:

1. Enter the Master code and hold down the last digit (2 beeps).
2. Press key ‘3’ (1 beep).

This is the low battery warning. When a code has been entered and the Safes battery is low, the unit will flash and beep several times to warn you. Change the battery immediately when you receive this warning.

When a code has been entered and the Safes battery is low, the unit will flash and beep several times to warn you. Change the battery immediately when you receive this warning.