YMI70A Smart Lock

PIN codes, fingerprints, RFID cards, mechanical keys, Bluetooth (BLE module), and Wi-Fi (Yale Connect X Bridge).

After authentication, push to enter and pull to exit. The direction is reversible during installation.

·  Press the R button

·  Enter the User code

·  Press the R button again

• Enter User code
• Press the R Button
• Press 4 > # > 1 > #
• Enter new Master code followed by #
• Re-enter the new Master code
• Press the R button to complete

• Enter the Master code
• Press the R button
• Press 1 followed by #
• Enter the new master code followed by #
• Re-enter the new master code
• Press the R button to complete

• Enter Master code
• Press the R button
• Press 3 > # > 1 > # > 1 > #
• Enter the slot ( Any numbers between 01-99 )followed by #
• Place the finger on the sensor 8 times
• Press * or R button to complete

• Enter Master code
• Press the R button
• Press 2 > # > 1 > #
• Enter the slot ( Any numbers between 01-99 )followed by #
• Enter the new User code followed by #
• Press * or R button to complete

Yes, with the BLE module and Yale Connect Wi-Fi Bridge using the Yale Home App.

Slide the interior button to activate. Disables all external access until deactivated manually.

Use a 9V battery on emergency terminals to temporarily power the lock and unlock it using your credentials.

Yes, the lock includes multi-language voice guidance for setup and operations.

• Enter the Master code
• Press the R button
• Press 6 > # > 2 # > 1 > #
• Press * or # to complete.

Yes, through Yale ConnectX Wi-Fi Bridge, it can integrate with Alexa, Google Assistant, etc.

The lock may have fully drained batteries. Replace all four AA alkaline batteries. If still unresponsive, apply a 9V battery to the emergency terminals at the bottom of the front panel to power up temporarily and unlock the door.

Ensure the Yale BLE module is securely installed inside the lock. Restart your smartphone and the Yale Home App, enable Bluetooth and location permissions, and make sure you're within 3 meters of the lock.

Clean the fingerprint sensor with a soft cloth. Re-register the fingerprint using the correct finger placement. Make sure your fingers are dry and not worn out or dirty.

Double-check the entered code for accuracy. If the lock entered lockout mode due to multiple wrong attempts, wait 3–5 minutes before trying again. Re-register the PIN if necessary, using the Master PIN.

This may indicate a mechanical misalignment or obstruction. Ensure the latch is properly aligned with the strike plate. Remove any physical obstructions and recalibrate the lock if needed.

This signals a low battery. Replace all four AA batteries with fresh alkaline ones immediately to prevent lockout.

Check that Auto Lock is. Ensure the door closes completely and the latch is fully engaged.

Check for dead batteries or door misalignment. Try opening the door with the mechanical key. If the problem persists, please contact Yale Technical Support.

You may have reached the maximum limit for fingerprints, PINs, or cards. Delete unused or inactive user entries to free up space.

After 5 consecutive failed access attempts, the lock enters lockout mode for security. Wait 3 to 5 minutes before trying again or use the mechanical key for immediate access.

Inspect the strike plate and frame alignment. Realign or adjust the strike plate to ensure smooth bolt movement.

Ensure you're holding the reset button (beneath the battery cover) for at least 10 seconds. Remove batteries for a minute and try again if reset fails initially.